ACCU-CAL™ 50 Radiometer - UV Intensity Meter for use with UV Spot Lamps & UV Flood Lamps
CE Marked Available Globally
The ACCU-CAL™ 50 radiometer UV intensity meter is a simple-to-operate device that measures UV-A (320-390nm) intensity and dose (energy). Degradation of UV curing bulbs, lightguides, and reflectors can significantly reduce intensity, resulting in incomplete cures.
The ACCU-CAL™ 50 allows operators to validate, monitor, and document a UV curing process. A low intensity measurement signals an operator to replace the bulb, lightguide, or reflector. The ACCU-CAL™ 50 can also be used to confirm that operators are properly shielded from UV exposure.
- Measurement range up to 40W/cm2
- Only one calibration per year
- Durable temperature-resistant sensor
- Comes with sturdy carrying case
- PTB and NIST traceable
ACCU-CAL™ 50 for spots, floods and conveyors.
ACCU-CAL™ 50 for floods and conveyors.
|ACCU-CAL™ 50 Radiometer Specifications|
|Spectral Sensitivity||320 to 395 nm|
|Intensity Range||1 mW/cm2 to 40 W/cm2|
|Resolution||Intensity (1 mW/cm2; to three significant digits)|
Dose (1 mJ/cm2)
|Calibration Period||12 months|
|Operating Temperature Ranges||Optometer: +5 to +40°C|
Detector: 120°C continuous, Peak 200°C
|Measurement Modes||Intensity (mW/cm2 and W/cm2)|
Peak Intensity (mW/cm2 and W/cm2)
|Light Sources||Lightguides (3 mm, 5 mm, and 8 mm) Floods/Conveyors|
|Power Supply||Two (2) AA batteries|
|Battery Life||250 hours (automatic shutoff after 1 hour)|
|Sensor Dimensions||Photo-Sensor Diameter = 9 mm|
Diameter = 37 mm
Thickness = 8 mm
Cable Length = 1 M
|Meter Dimensions||120 mm (Length) x 65 mm (Width) x 23 mm (Thickness)|
*A lightguide simulator is used to measure direct spot lamp intensity (required to calculate lightguide transmission)
|RADIOMETERS and ACCESSORIES|
|ACCU-CAL™ 50 for Flood Lamps and Conveyors||39561||Complete radiometer (without lightguide adapters or lightguide simulator*); includes storage/carrying case|
|ACCU-CAL™ 50 for Spot and Flood Lamps and Conveyors||39560||Complete radiometer with lightguide adapters (3 mm, 5 mm, and 8 mm) and lightguide simulator*; includes storage/carrying case)|
|Flood to Spot Adapter Kit||39554||Kit includes three lightguide adapters (3 mm, 5 mm, and 8 mm) and lightguide simulator*|
|3 mm Lightguide Adapter||39556||Fits 3 mm ID lightguides (5 mm OD)|
|5 mm Lightguide Adapter||39557||Fits 5 mm ID lightguides (7 mm OD)|
|8 mm Lightguide Adapter||39558||Fits 8 mm ID lightguides (10 mm OD)|
|5 mm Lightguide Simulator*||38408||5 mm lightguide simulator* with a standard D connection|
If you're not sure which curing system is the right one for you, Max says to Click here to evaluate UV technology for two weeks FREE! with a DYMAX lamp through our Equipment Trial Rental/Lease Program.